Vacuum Tubes

Miniature remote-cutoff pentode primarily designed for use as a high-gain radio-frequency or intermediate-frequency amplifier. Features include small size, low grid-plate capacitance, and high transconductance

Miniature, medium-mu triode suitable for use in a wide variety of general purpose applications. It is especially useful as a local oscillator in high-frequency and very-high-frequency receiver circuits.

9 pin miniature preamp tube (Amplification Factor = 100). This Russian tube has strong lows and bright highs. Its lows demand attention when playing full bar chords. In overdrive, it offers a lot of crunchy fizz.

Tung Sol 6L6GC “STR” beam-power tetrode tube. Made in Russia. The Tung-Sol legacy continues with the introduction of the new 6L6GC STR. The ultimate in musical tone and smooth overdrive, the STR delivers the sound that established Tung-Sol as the benchmark of quality. Built to the same “Special Tube Request” specs of leading amplifier manufacturers of the 1960s, the 6L6GC STR is a rugged and reliable power tube for use in the most demanding guitar amplifier circuits.

Tung Sol 6SN7GTB dual triode preamp tube. Made in Russia. Super linearity, low noise, and full performance ratings make this one of the best 6SN7 tubes ever made. The sound signature is on par with 5692 types. Excellent driver tube in high-end audio applications.

The JJ Electronic 6SL7 is a great reproduction of the classic octal based dual triode. This tube has the quality construction and reliability that one would expect from a JJ tube. The JJ 6SL7 is a great replacement tube for any 6SL7 position such as early Fender, Gibson, and Ampeg amps as well as Hi-Fi equipment.

Mullard 12AX7 / CV4004 dual triode preamp tube. Made in Russa. The CV4004/12AX7 is a high gain, low noise valve with a short plate structure for reduced microphonics. Excellent for use in high gain Marshall pre-amplifier circuits where noise and microphonics can be a problem. Great for guitar amps.

Electro-Harmonix 12AY7/6072 Twin triode preamplifier tube used in Fender Tweed amplifiers.

Tube Amp Doctor 5AR4 Rectifier, Premium Selected. A faithful reproduction of the Mullard/VALVO GZ34. Pure power and the typical sag is the distinguishing characteristic of the most popular guitar amps of the 1960s guitar heroes till today.

The JJ Electronic 7591 is a reliable and accurate reproduction of the classic tube. This 19 Watt pentode has been used in a variety of amplifiers including Hi-Fi amps and Ampegs. The JJ 7591 is a great replacement for any 7591 tube position.

Superior directly heated rectifier Diode. Replacement for all 5U4 types, including NOS-style "big bottle" tubes.

Miniature heater-cathode type twin diode designed for full-wave rectifier operation in compact power supplies. The tube is intended for service in automobile and a-c radio receivers.

The Psvane EL34 is a high quality octal power tube with a maximum plate power of 25W. Psvane improved the plate structure of the classic EL34B to produce a tube with increased reliability. The Psvane EL34C offers classic British tone in any amp. The Psvane Classic Series is focused on the reproduction of popular vacuum tubes found in classic audio equipment. When designing the Classic Series, Psvane collected the most sought-after NOS tubes and analyzed each element of their construction, incorporating the most effective manufacturing techniques to produce stable tubes with excellent sound. Whether used in guitar amplifiers or hifi stereo systems, the Psvane Classic Series vacuum tubes excel in all applications. Psvane has been producing high quality vacuum tubes since 2011. The Psvane team originally formed in Shuguang’s high-end tube division but eventually split off to form their own brand.

Solid State Rectifier Direct plug-in replacement for 5AR4, 5U4 and 5Y3 rectifier vacuum tubes in amplifiers with center tapped secondary power transformer. Use when less 'sag' is desired in the power supply; just switch back to the tube rectifier when 'sag' is desired.

The Sovtek EL84 series produce an unbeatable smooth, warm, distortion. Excellent replacements in vintage VOX AC-30s and the like. Tube measurements are as follows:

• Height: 2.75” (without pins)*
• Diameter: 0.87”*

*Note: Due to the method of production in regards to the glass, measurements may vary slightly.

The TAD ECC81 / 12AT7-Cz is selected with regards to a tight balance of both triodes making it ideal for the use as a balanced phase inverter. In addition to the perfect symmetrical systems, the strong amplification characteristics of the TAD ECC81 / 12AT7-Cz support increased dynamics of the output stage when used as phase driver or phase inverter tube. Q: When does a power tube become a Premium Selected power tube? A: All power tubes labeled Premium Selected have passed the following tests:

• Plate Current (PC) and Amplification (TC)
• Low Noise Test
• Microphonic Test
• Sonic Tests
• Shock Tests
• Listening Tests
• Shorts & Leakage Tests

Alternative to the 12AX7 or ECC83. The JJ Electronic E83CC is a high quality dual triode that rivals the NOS version of this tube. The E83CC was originally designed as an audio specific dual triode with very low noise and microphonics. The JJ E83CC stays true to the original design with the signature thick frame grid and boxed plate. The rigid frame allows for tighter tolerances and closer construction which results in lower noise and increased stability. The JJ Electronic E83CC is a great choice for high fidelity amplifiers as well as guitar amps and studio equipment. The E83CC has the same pinout and amplification factor as a standard 12AX7 and can be used in any 12AX7 or ECC83 position. Guitarist Description: This frame grid tube has an incredibly rich yet balanced tone. The E83CC works well for clean sounds but also breaks up with a satisfying warmth and plenty of articulation.

Voltage Regulator, Diode, Glow-Discharge type.

Superior medium-Mu Twin Triode for use in preamplifier and driver circuits. Standard replacement for all circuits requiring 12AU7/ECC82 types.

The all-new designed TAD 12AX7 / ECC83 Redbase is a miniature, high-mu twin triode with very good gain. These tubes are selected and recommended for guitar amps to improve overall responsiveness and dynamics. Because of its cathode-to-heater voltage-withstand capability, this tube works perfectly as a cathode follower. Best for thick, clean tones as well as for those modern preamps where a deep low end is required as well as for sounds requiring fat midrange, detailed airy top end and lots of power from the preamp. Recommended for all positions in medium gain amps or for V2+ positions in high-gain amps. For V1 in general but especially for high-gain amps or phono/audio-amps, we recommend the new 7025 / E83CC Redbase Highgrade T-7025-RB-TAD.

Metal sharp-cutoff pentode designed for use as a biased detector or high-gain amplifier.

Superior medium-mu twin triode driver tube for hifi use. 3.5 watts dissipation per plate. New design of excellent quality

Remote-cutoff pentode. It is designed for use as a high-gain radio-frequency or intermediate-frequency amplifier in a radio receiver.

Superior power Beam tetrode with large plate dimensions and improved grid structure for increased power handling capabilities. Excellent tone and performance compared to most other 6L6 or KT66 types.