Vacuum Tube Accessories

8 pin tube base with gold pins.
Outer Diameter: 1.20"
Inner Diameter: 1.16"
Height (not including pins or keyway): 0.79"

9-pin ceramic tube socket for auto-wave soldering applications.
Measurements:

• Center PCB hole diameter -0.73"
• Mounting pin diameters - (9 holes at 1.00") and (3 holes at 1.26")

The YJUni is a simple pin-converting adapter for use in most amps with 6V6 or similar based tubes like 6F6, 6G6, 6K6, 6Y6, etc. The YJUni is shorter than standard Yellow Jacket® converters. It is designed for use in lower power output amps (20 watts or less) when no power reduction is desired.

This is a set of measured vacuum tubes for use in TV-7 vacuum tube tester calibration. The values for each vacuum tube will be measured and included for the purpose of calibrating your own TV-7 tester at home. Steps for this calibration can be found online. Three tubes will be included:

• 6L6
• 6AU6
• 12AT7

These tubes are tested at the following settings: Tube Filament Settings Bias Shunt Range 6L6 6.3 HS5-3481 23 0 D Tube Filament Settings Bias Shunt Range 6AU6 6.3 ET1-5672 16 0 B Tube Filament Settings Bias Shunt Range 12AT7 12.6 EV7-6080 10 0 C Note that brands are not guaranteed to match photograph.

7-pin ceramic plate socket used for 6C33B,829B and 3E29 sized tubes. Bossed mounting holes and recessed rivets allow sub-panel mounting .

• Bottom mount
• 1 ¼" chassis hole required
• 1-⅞" x 1-⅞" oblong mounting centers

8 pin tube base with gold coated pins.
Outer Diameter: 1.57"
Inner Diameter: 1.52"
Height (not including pins or keyway): 0.80"

4-pin jumbo ceramic bayonet socket used for 211 and 845 tubes.

• Top mount
• 2-13/16" mounting centers
• Available with standard or gold plated pins

Made in China. Aluminum tube shield (with base), spring loaded, for short 9 pin miniature tubes like NOS 6386 with 1.50" seated height. (Too short to fit more common 9 pin miniature tubes like 12AX7 with 1.94" seated height).

7-pin ceramic plate socket used for 813 tubes. Bossed mounting holes and recessed rivets allow sub-panel mounting. Made in China

• Bottom mount
• 1 ¼" chassis hole required
• 1-⅞" x 1-⅞" oblong mounting centers

9-pin Micalex ceramic tube socket for auto-wave soldering applications.
Measurements:

• Center PCB hole diameter -0.73"
• Mounting pin diameters - (9 holes at 1.00") and (3 holes at 1.26")