Vacuum Tube Accessories

Do you have valuable octal type tubes that work fine except the keyway has been broken off the base? Fix it with this simple and inexpensive product. Simply clean the remainder of the broken keyway from the base and slip one of these on. Will stay on by itself, or you can use a dab of silicon to attach if you wish.

Replacement foam tube stabilizer for Fender® Hot Rod Deluxe and Hot Rod Deville amps. This foam block slides over the first two preamp tubes. This genuine Fender® replacement is made in the USA.

This adapter allows you to use 6GH8A or 6U8A tubes in place of the difficult-to-find 7199. Tubes are not included.

15 x 15" egg crate packing box designed for storing tubes. Supplied unassembled. Each size is capable of holding a different number of tubes. For cartons see S-B127X

Includes:

• (1) T-7199-ADT
• (1) T-6GH8A

Single socket, 2 rows/6 lugs per row, 4 mounting holes. Board dimensions 3" x 3". Terminals are not pre-wired.

The YJS is a specialized, current-limiting/voltage-conditioning adapter for use in most 20 to 100 watt amps that use 6L6, EL34, 6550 or 6V6 output tubes. The YJS is for amps with fixed bias power tubes. (Fixed bias tubes have their cathode connected directly to ground and a negative DC voltage applied to their control grid).

The YJUni is a simple pin-converting adapter for use in most amps with 6V6 or similar based tubes like 6F6, 6G6, 6K6, 6Y6, etc. The YJUni is shorter than standard Yellow Jacket® converters. It is designed for use in lower power output amps (20 watts or less) when no power reduction is desired.

Dual socket. 2 rows/12 lugs per row, 4 mounting holes. Board dimensions 5 ¼" x 3". Terminals are not pre-wired.

The YJShort is shorter than the standard YJS converter, allowing for use in amps that do not have room for the standard converters. It is a specialized, current-limiting/voltage-conditioning adapter for use in most 20 to 100 watt amps which use 6L6, EL34, 6550 or 6V6 output tubes

This is a set of measured vacuum tubes for use in TV-7 vacuum tube tester calibration. The values for each vacuum tube will be measured and included for the purpose of calibrating your own TV-7 tester at home. Steps for this calibration can be found online. Three tubes will be included:

• 6L6
• 6AU6
• 12AT7

These tubes are tested at the following settings: Tube Filament Settings Bias Shunt Range 6L6 6.3 HS5-3481 23 0 D Tube Filament Settings Bias Shunt Range 6AU6 6.3 ET1-5672 16 0 B Tube Filament Settings Bias Shunt Range 12AT7 12.6 EV7-6080 10 0 C Note that brands are not guaranteed to match photograph.