You are here

Semiconductors

Filter these results
Sort By:
products per page
View Mode: List View · Grid View
P-QPC1188HIntegrated Circuit - Fender®, Power Amp PC1188H

PC 1188H Power Amp - Fender The PC1188H is a monolithic integrated circuit and a power amplifier designed for Hi-Fi audio sets. The PC1188H can provide 20W (typical) to 8 ohms at 1% T.H.D. and +/- 22V supply voltage. Features:



  • High output power
  • Low distortion
  • Wide frequency bandwidth
  • A muting function which eliminates pop on noise and the thermal and the over current protection circuit

Please Log In to
view prices
Click to read more
P-QMPS6531Transistor - Peavey, MPS 6531, NPN Amplifier, 40V, TO-92

MPS 6531, NPN general purpose amp, 40V, TO-92 Case.


Please Log In to
view prices
Click to read more
P-QMPS6533Transistor - Peavey, MPS 6533, PNP Amplifier, 40V, TO-92

MPS 6533, PNP general purpose amp, 40V, TO-92 Case.


Please Log In to
view prices
Click to read more
P-QLM324Op-Amp - LM324, Quad, Low-Power, 14-Pin DIP

Quad low-power opamps in an 14-pin DIP package. The LM324 offers a 1MHz bandwidth and can be powered from a single supply.


Please Log In to
view prices
Click to read more
P-QQ4025PTriac - Q6025P5 - Alternistor, 600V, 25A, Fastpack TO-3 Base

Alternistors are specifically designed for applications which are required to switch highly inductive loads. To accomplish this, a special chip has been designed which effectively offers the same performance as two thyristors (SCRs) wired inverse parallel (back to back); hence the alternistor has better turn-off behavior than a standard triac.


Please Log In to
view prices
Click to read more
P-QSBS14Diode Thyristor - Peavey, SBS 14 Bidirectional, 8V, TO-92 Case

Designed for full-wave triggering in Triac phase control circuits, half-wave SCR triggering application and as voltage level detectors. Used in most Peavey linear power amplifier designs through 2000 including CS/M/DECA series power amps, IPA300, and all models using 402/602/304S/204S power modules.



  • Low Switching Voltage — 8 Volts Typical
  • Uniform Characteristics in Each Direction
  • Low On-State Voltage — 1.7 Volts Maximum
  • Low Off-State Current — 0.1 mA Maximum

Please Log In to
view prices
Click to read more
P-QTIP41CTransistor - TIP41C, NPN Epitaxial Transistor
Transistor TIP41C, TO-220 Case.
NPN Epitaxial Silicon Transistor
Complementary to TIP42 (P-QTIP42C)
Max ratings:
  • Collector-Base voltage = 100V
  • Collector-Emitter Voltage = 100V
  • Emitter-Base Voltage = 5V
  • Collector current (DC) = 6A
  • Collector current (Pulse) = 10A
  • Base current = 2A
Please Log In to
view prices
Click to read more
P-QTIP42CTransistor - TIP42C, PNP Epitaxial Transistor
Transistor TIP42C, TO-220 Case.
PNP Epitaxial Silicon Transistor
Complementary to TIP41 (P-QTIP41C)
Max ratings:
  • Collector-Base voltage = -100V
  • Collector-Emitter Voltage = -100V
  • Emitter-Base Voltage = -5V
  • Collector current (DC) = -6A
  • Collector current (Pulse) = -10A
  • Base current = -2A
Please Log In to
view prices
Click to read more
P-QHFA16TDiode - Hexfred, 16A, 600V
High performance, ultrafast diodes. Improve efficiency, reduce noise, allow higher frequency operation.
Please Log In to
view prices
Click to read more
P-QLF353Op-Amp - LF353, Dual, Wide-Bandwidth, JFET Input, 8-Pin DIP

Dual wide-bandwidth LF353 opamps in an 8-pin DIP package. The LF353 offers a high input impedance and 3MHz bandwidth.



This LF353 device is a low-cost, high-speed, JFET input operational amplifier with very low input offset voltage. It requires low supply current yet maintains a large gain-bandwidth product and a fast slew rate. In addition, the matched high-voltage JFET input provides very low input bias and offset currents.


Please Log In to
view prices
Click to read more
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Semiconductors