Semiconductors

Diode - 1N914, Small Signal
The 1N914 is a small signal diode similar to the 1N4148 and is common in many older electronics. The 1N914 is general purpose and can be used in a multitude of different applications.
Please Log In to view prices
Integrated Circuit - SSI2144, Ladder VCF, Sound Semiconductor
The second of two legendary SSM filter updates, the FatKeys™ SSI2144 is a dedicated four-pole low-pass ladder filter with on-chip resonance control. Original designer Dave Rossum did a number of performance updates such as lower noise, improved control feedthrough, and logical pin grouping but otherwise left this sweet-sounding VCF alone. The SSI2144 reprises the SSM2044 of legacy chipmaker Solid State Micro Technology, which many believe to be the best-sounding analog synthesis filter IC ever produced. Based on Dave Rossum’s patented classic improved ladder topology, the SSI2144 allows rich tonal characteristics that showcase the very best attributes of subtractive synthesis. The SSI2144 uses the same internal circuit as the SSM2044 but incorporates improvements by the original designer and takes advantage of modern process technology.
Please Log In to view prices
Op-Amp - BA4560, Dual, General Purpose, 8-Pin DIP
The BA4560, is a dual operational amplifiers which achieves approximately twice the high output current of the BA4558, as well as featuring a higher slew rate of 4V / µs, a gain band width of 10MHz, and an improved frequency characteristic. 8-pin DIP package.
Please Log In to view prices
Diode - BAT41, Schottky, Small Signal
The BAT41 is a schottky diode used in many DIY projects. General purpose metal to silicon diode featuring very low turn-on voltage and fast switching. This device has integrated protection against excessive voltage such as electrostatic discharges.
Please Log In to view prices
Diode - Silicon Rectifier, 3A, 400V, 1N5404
A semiconductor device which passes current in the forward direction(from anode to cathode), and blocks current in the opposite direction.
Please Log In to view prices
Op-Amp - TL074, Quad, Low-Noise, JFET Input, 14-Pin DIP
Low noise JFET quad operational amplifier. Incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. Features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficients. Features:
  • Wide common-mode and differential voltage range
  • Low input bias and offset current
  • Low noise en = 15 nV/HZ
  • Output short-circuit protection
  • High input impedance JFET input stage
  • Low harmonic distortion: 0.01%
  • Internal frequency compensation
  • Latch up free operation
  • High slew rate: 16 V/us (typical)
Please Log In to view prices
Op-Amp - LM741, Single, general purpose, 8-Pin DIP
LM741 single opamp in an 8-pin DIP package. The LM741 has been used in classic guitar pedals such as the Distortion Plus.
The LM741 series are general purpose operational amplifiers which feature improved performance over industry standards like the LM709. They are direct, plug-in replacements for the 709C, LM201, MC1439 and 748 in most applications. The amplifiers offer many features which make their application nearly foolproof: overload protection on the input and output, no latch-up when the common mode range is exceeded, as well as freedom from oscillations.
Please Log In to view prices
Op-Amp - TL082, Dual, Wide-Bandwidth, JFET Input, 8-Pin DIP
Dual wide-bandwidth TL082 opamps in an 8-pin DIP package. The TL082 offers a high input impedance and 4MHz bandwidth.
Please Log In to view prices
Op-Amp - TL062, Dual, Low-Power, JFET Input, 8-Pin DIP
Dual low power opamps in an 8-pin DIP package. The TL062 offers a high input impedance and 1MHz bandwidth.
Please Log In to view prices
Transistor - 2N3906, TO-92 case, PNP
General purpose low-power PNP bipolar junction transistor, used frequently in hobbyist electronic projects. For the NPN 2N3904 see P-Q2N3904
Please Log In to view prices
Diode - Fast Recovery, 1A, 600V, 1N4937
A semiconductor device that, above a certain reverse voltage(the zener value) has a sudden rise in current. If forward biased, the diode is an ordinary rectifier. When reverse biased, it exhibits a sharp break in its current-voltage graph. Voltage across the diode remains essentially constant for any further increase of reverse current.
Please Log In to view prices
Op-Amp - LF353, Dual, Wide-Bandwidth, JFET Input, 8-Pin DIP
Dual wide-bandwidth LF353 opamps in an 8-pin DIP package. The LF353 offers a high input impedance and 3MHz bandwidth.
This LF353 device is a low-cost, high-speed, JFET input operational amplifier with very low input offset voltage. It requires low supply current yet maintains a large gain-bandwidth product and a fast slew rate. In addition, the matched high-voltage JFET input provides very low input bias and offset currents.
Please Log In to view prices
LED - 3mm diameter, diffused lens, 3.6 mCd
Package of 5
Colors Available:
New!:
Lens Diameter: 3 mm Overall Height: 5.4 mm Lens Type: Diffused Multiple color options available.
Please Log In to view prices
Op-Amp - LM324, Quad, Low-Power, 14-Pin DIP
Quad low-power opamps in an 14-pin DIP package. The LM324 offers a 1MHz bandwidth and can be powered from a single supply.
Please Log In to view prices
Diode - General purpose rectifier, 1A, 1N400X
A semiconductor device which passes current in the forward direction (from anode to cathode), and blocks current in the opposite direction.
Please Log In to view prices
Audio Power Amplifier - LM386N-1, Low Voltage
LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.
Please Log In to view prices
Integrated Circuit - DAB2130, VCO, Sound Semiconductor
The Sound Semiconductor DAB2130 is a pre-soldered DIP converter for the SSI2130. This board features the SSI2130 and two decoupling caps for the V+ and V- inputs. The pinout is labelled on the board and matches the QFN pinout. This adapter features a 32 pin DIP base with a .600 in. width. The pins are standard male headers so 2.54mm female headers are recommended for socketing the board. For the standard QFN version, please see P-Q-SSI2130. The first new VCO IC in decades, and worth the wait! The FatKeys™ SSI2130 Voltage Controlled Oscillator provides beautiful triangle, sawtooth, pulse, and square waveforms with unprecedented temperature stability; and adds an on-chip mixer, low distortion sine wave generator, through-zero FM/PM capability and more in an ultra-compact PCB footprint. The SSI2130 is a new-generation voltage controlled oscillator subsystem for high-performance electronic musical instruments.
Please Log In to view prices
Transistor - 2N5087, Bipolar, General Purpose, PNP
2N5087 PNP Bipolar Junction Transistor in TO-92 package. For the NPN 2N5087 see P-Q2N5088
Please Log In to view prices
Transistor - Peavey, SJE 5332, 120V, 3A
SJE 5332, 120V, 3A, PNP. Case-77.
Please Log In to view prices
Transistor - 2N7000, Mosfet, Small Signal
2N7000 N-channel enhancement mode field effect transistors. 2N7000 MOSFETs are used in many DIY projects such as boost and distortion effects pedals.
Features:
  • Voltage Controlled Small Signal Switch
  • High Saturation Current Capability
  • Rugged and Reliable
  • High Density Cell Design for Low RDS(ON)
Please Log In to view prices
Integrated Circuit - SSI2162, Dual VCA, Sound Semiconductor
The FatKeys™ SSI2162 provides two independent VCA channels, and like its SSI2161 and SSI2164 siblings offers great flexibility in design of dynamics processors, automatic or remote level control, and voltage controlled filters. Highly compact 10-lead SSOP package. The SSI2162 is a versatile VCA building block for high-performance audio applications. Two independent channels provide voltage control of a current-mode input and output for a gain range from +20dB to –100dB, with control provided by a ground-referenced –33mV/dB constant. The device offers considerable flexibility for a wide range of design goals and applications. A unique mode control allows selection of Class A, Class AB, or in-between using a single resistor. In addition, improved current handling allows use of lower value input resistors for reduced output noise without loss of headroom. Both channels can be parallel-connected for further noise improvement.
Please Log In to view prices
Transistor - TIP42C, PNP Epitaxial Transistor
Transistor TIP42C, TO-220 Case.
PNP Epitaxial Silicon Transistor
Complementary to TIP41 (P-QTIP41C)
Max ratings:
  • Collector-Base voltage = -100V
  • Collector-Emitter Voltage = -100V
  • Emitter-Base Voltage = -5V
  • Collector current (DC) = -6A
  • Collector current (Pulse) = -10A
  • Base current = -2A
Please Log In to view prices
Transistor - TIP41C, NPN Epitaxial Transistor
Transistor TIP41C, TO-220 Case. NPN Epitaxial Silicon Transistor Complementary to TIP42 (P-QTIP42C) Max ratings:
  • Collector-Base voltage = 100V
  • Collector-Emitter Voltage = 100V
  • Emitter-Base Voltage = 5V
  • Collector current (DC) = 6A
  • Collector current (Pulse) = 10A
  • Base current = 2A
Please Log In to view prices
Integrated Circuit - Marshall, TDA7293 amplifier
120V - 100W DMOS audio amplifier with mute/standby. The TDA7293 is a monolithic integrated circuit in Multiwatt15 package, intended for use as audio class AB amplifier in Hi-Fi field applications, such as home stereo, self powered loudspeakers and Topclass TV. Thanks to the wide voltage range and to the high output current capability it is able to supply the highest power into both 4-Ω and 8-Ω loads.
Please Log In to view prices