Radio & Antique Equipment Parts

Relay - SPDT, Leslie 122 Retrofit
Reliable replacement relay for the Leslie 122. The small size makes this high quality relay easy to retrofit in the 122. Its performance exceeds the original relays used in the Leslie 122 with its very low switching noise and high ratings on both the contacts and the coil.
Features:
  • 8 mm, 6 kV (1.2/50 µs) isolation, coil-contacts
  • Coil EMC suppression
  • Cadmium Free contact material
Please Log In to view prices
Washer - ⅞" x ⅛" Thick, Rubber, Chassis Mount,
Gum rubber chassis mounting washers as used on thirties vintage Zenith and Philco radio. 1/4 inner dia. Allows proper dial centering in cabinet opening. Adhesive backing for lamenating to other washers to increase thickness. Overall dimensions 7/8" dia. x 1/8" thick.
Please Log In to view prices
Spring - Leslie, Tension, for Upper Belt
Replacement upper belt tension spring for Leslies.
Please Log In to view prices
Wire - 18 Gauge, 2 conductor, braided Power Cord
Brown 2 conductor 18 gauge, stranded power cord, similar to woven cloth covered cords in early AC radios. 105°C temperature rating, 600V.
Please Log In to view prices
Knob Springs - for half moon / D shafts
Package of 6
Assortment of knob springs for 1/2 moon shaft. 3/8" high x 9/32" outside dia. "D" shaped package of 6.
Please Log In to view prices
Bearing - Leslie, Lower Rotor, sealed
Sealed lower rotor bearing for Leslies.
Please Log In to view prices
Power Supply - Power-All® ECO-Dapter®, Cable Kits, for Effects Pedals
Power-All® ECO-Dapter® is a center negative 9VDC power supply for effects pedals that can supply up to 2000mA of power making it a great choice for pedals boards and power hungry effects. Power-All® kits include a variety of useful cables for powering multiple pedals to the ECO-Dapter® 9V supply.
Please Log In to view prices
Transformer - Hammond, Radiola III-A Replacement Audio
Developed in response to requests from RCA Radiola III-A collectors. The original transformers are usually found with open" windings due to the fine wire and high turns usedcoupled with age. This is a universal replacement type - it will replace any of the three audio transformers used (1st audio driver2nd audio-phase splitter stage or output transformer)by correctly connectiong the 5 lugs. A pin out and connection diagram is included. The cases from the old transformer will fit this new unit. The terminal board is a duplicate of the original.
Key Features
  • Primary: 4000 turns, #41 wire (lugs 4 & 2)
  • Secondary: 12000 turns C.T., #41 wire (lugs 5 & 1lug 3 is C.T. connection)
  • Termination: Solder lugs on a 1 3/4" x 1" terminal board with 4-5" connecting leads
  • Size: 1-7/8" long x 1-11/16" wide x 1-3/8" deep
  • Lamination Core Size: 5/8" x 1/2"
  • Weight: 7 oz.
Please Log In to view prices
Socket - Leslie, 6 Pin Female, wavy washer
6 pin female socket with wavy washer, for Leslies.
Please Log In to view prices
Cable - Power All, 5 Lead Right Angle Daisy Chain
Right Angle Daisy Chain connector with standard polarity tip negative/barrel positive plugs connects the Power-All® ECO-Dapter® 9 VDC power supply to five effect pedals. The Cable-5/R can also be used with Power-All jumper cables to power effects that use different style jacks (reverse polarity, phone plug, battery clip, etc.). You can also link multiple Cable-5/R connectors to power over twenty 9-volt effect pedals or similar devices (actual number of units depends on current draw of individual units used).
Please Log In to view prices
Power Supply - Power-All® ECO-Dapter®, 9V, 2000mA, for Effects Pedals
Power-All® ECO-Dapter® is a center negative 9VDC power supply for effects pedals that can supply up to 2000mA of power making it a great choice for pedals boards and power hungry effects.
Please Log In to view prices
Vibrator - 12 Volt, 3 Pin, Negative Ground
New manufacture solid-state replacements for 12 volt, 3 pin vibrators with a negative ground. These replace our old line of solid state vibrators. 1 1/2 dia. x 2 ¾" high aluminum can. Replace your buffer capacitor when you replace your vibrator!
Please Log In to view prices
Grommet Kit - All Rubber Parts, for Leslie
Package of 33
Replace deteriorated rubber parts in Leslie cabinets. Includes grommets, o-rings, bushings, plug.
Please Log In to view prices
Cable - Power All, Black Right Angle Extension Jumper
Included in the PA-9ECD Deluxe Kit and also sold separately, the Cable-Black/R allows the user to power over-sized effect units or units w/AC jacks in hard-to-reach places off of the Power-All Daisy Chain. The Cable-Black can be connected to any plug on any Power-All daisy chain, or directly to the ECO-Dapter® itself.
Please Log In to view prices
Power Supply - Dunlop, 9V, 200mA, Barrel, Center Negative

Dunlop ECB003 US wallwart power supply. Barrel connector.

  • Voltage: 9VDC
  • Current: 200mA
  • Tip Negative; Sleeve positive
Please Log In to view prices
Plastic Polish - Novus #3, heavy scratch remover
Removes scratches from acrylic surfaces; significantly reduces haziness. More abrasive than Novus #2 and is effective for deeper scratches. Treatment should be followed by Novus #2 to buff and polish surface.
Please Log In to view prices
Diode - 1N34A Germanium, low leakage
The 1N34A Germanium diode is an old standby in electronics. Widely used for detecting the rectifying efficiency or for switching on a radio, TV or stereo etc.
Please Log In to view prices
Cable - Power All, Green Right Angle Line-6 Extension Jumper
Included in the PA-9ECB Basic Kit, PA-9ECD Deluxe Kit, and also available separately, the Cable-Green Right Angle jumper allows the user to power Line-6 Stomp-Box modelers and other digital effect units from the ECO-Dapter®. The Cable-Green features a reverse-polarity (tip positive), right-angle male barrel connector with a larger, 2.5 mm internal diameter and spring-loaded clips. The Cable-Green/R can be used with Line-6 Modelers, Electro-Harmonix units, and other pedals requiring a larger internal diameter plug. the Cable-Green/R can be connected to the male plugs on any Power-All Daisy Chain, or directly to the ECO-Dapter® itself.
Please Log In to view prices
Switch - for Run Circuit in Hammond Organ
Switch for run circuit in Hammond Organ. Electrical Rating: 16 A - 125 V 8 A - 250 V Dimensions: Mounting Diameter: ½" Bushing Length: 0.425" Length: 1.89" Width: 0.82" Depth: 0.69"
Please Log In to view prices
Plastic Polish - Novus #2, fine scratch remover
Removes fine scratches, abrasions and haziness from plastic surfaces. Great for plastic radio dial windows. For best results, follow with Novus No. 1 polish.
Please Log In to view prices
Wire - 20 AWG Stranded Core, Lacquered Cloth Cover, 600V
Colors Available:
#20 stranded copper wire with modern insulation and lacquered cotton braid finish. Provides safety and authentic vintage look. 105°C temperature rating, 600V. For a solid core version, see: S-W8XL
Please Log In to view prices
Cable - Power All, Red Right Angle Reverse Polarity Jumper
Included in the PA-9ECB Basic Kit, PA-9ECD Deluxe Kit, and also available separately, the Cable-Red/R allows the user to power effect units that have reverse polarity barrel connectors (tip positive/barrel negative). The Cable-Red/R features a tip positive, male barrel connector that is spring-loaded to prevent disconnection. The Cable-Red/R can be hooked to any plug on any of the Power-All daisy chains, or directly to the Power-All.
Please Log In to view prices
Motor Assembly - Lower Slow, for Leslie 122/147
Replacement lower slow motor assembly for Leslie models 122/147. Overall shaft length is 2.75".
Please Log In to view prices
Fahnestock Clip - electrical terminal for wire connections
Spring clip ¾" long for up to 15 ga. wire. Hole fits U.S. Screw size # 6.
Please Log In to view prices