Radio & Antique Equipment Parts
Transformer - Hammond, Radiola III-A Replacement Audio
Developed in response to requests from RCA Radiola III-A collectors. The original transformers are usually found with open" windings due to the fine wire and high turns usedcoupled with age. This is a universal replacement type - it will replace any of the three audio transformers used (1st audio driver2nd audio-phase splitter stage or output transformer)by correctly connectiong the 5 lugs. A pin out and connection diagram is included. The cases from the old transformer will fit this new unit. The terminal board is a duplicate of the original.
- Primary: 4000 turns, #41 wire (lugs 4 & 2)
- Secondary: 12000 turns C.T., #41 wire (lugs 5 & 1lug 3 is C.T. connection)
- Termination: Solder lugs on a 1 3/4" x 1" terminal board with 4-5" connecting leads
- Size: 1-7/8" long x 1-11/16" wide x 1-3/8" deep
- Lamination Core Size: 5/8" x 1/2"
- Weight: 7 oz.
Cable - Power All, Grey Battery Snap Jumper
Included in the PA-9ECB Basic Kit and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack. The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.
Power Supply - Power-All® ECO-Dapter®, Cable Kits, for Effects Pedals
Power-All® ECO-Dapter® is a center negative 9VDC power supply for effects pedals that can supply up to 2000mA of power making it a great choice for pedals boards and power hungry effects. Power-All® kits include a variety of useful cables for powering multiple pedals to the ECO-Dapter® 9V supply.
Screw Set - Leslie, Back Panel, 13 Phillips Screws, Washers
Package of 13Set of 13 phillips head screws for Leslies. Includes 13 flat washers. 13 pieces replaces all of the screws on the upper cover, lower cover and middle back panel.
Bearing - Leslie, Upper Tension Idler
Sealed upper tension idler bearing for Leslies
Nut - Wire nut, Small size for 16 - 18 gauge wire
Package of 12Small wire nuts, for use on appliances, televisions, stereos, antennas, or for any small wiring application.
Cable - Power All, 11 Lead Right Angle Daisy Chain
Designed for larger pedalboards, the Power-All Cable-11/R Daisy Chain features ELEVEN right-angle male barrel plugs with spring loaded jacks for extra secure connections – no more losing power mid-solo! 28-gauge cable with oil-resistant sheath and 10-inch cable length between plugs allows connection of larger and odd-sized pedals.
Grommet Kit - All Rubber Parts, for Leslie
Package of 33Replace deteriorated rubber parts in Leslie cabinets. Includes grommets, o-rings, bushings, plug.
Relay - SPDT, Leslie 147 Retrofit
Reliable replacement relay for the Leslie 147. The small size makes this high quality relay easy to retrofit in the 147. Its performance exceeds the original relays used in the Leslie 147 with its very low switching noise and high ratings on both the contacts and the coil. Features:
- 8 mm, 6 kV (1.2/50 µs) isolation, coil-contacts
- Coil EMC suppression
- Cadmium Free contact material
Cable - Power All, Green Right Angle Line-6 Extension Jumper
Included in the PA-9ECB Basic Kit, PA-9ECD Deluxe Kit, and also available separately, the Cable-Green Right Angle jumper allows the user to power Line-6 Stomp-Box modelers and other digital effect units from the ECO-Dapter®. The Cable-Green features a reverse-polarity (tip positive), right-angle male barrel connector with a larger, 2.5 mm internal diameter and spring-loaded clips. The Cable-Green/R can be used with Line-6 Modelers, Electro-Harmonix units, and other pedals requiring a larger internal diameter plug. the Cable-Green/R can be connected to the male plugs on any Power-All Daisy Chain, or directly to the ECO-Dapter® itself.
Power Supply - Dunlop, 9V, 200mA, 3.5mm Positive Tip
This AC adapter powers several older models of Dunlop pedals, which required a 3.5 mm, or 1/8”, plug as opposed to the 5.5mm x 2.1mm barrel plug required by current models.
- Voltage: 9VDC
- Current: 200mA
- Tip positive; Sleeve negative