You are here

Potentiometers

Potentiometers are used to control volume and tone. A potentiometer is a three-terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider.
Check out our Tech Corder articles on pots, including Potentiometer Types.

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(16 pages)
R-VPE500KASPL-1Potentiometer - PEC Guitar, 500K, Audio, Long Bushing

Precision Electronic Components (PEC) Potentiometers are very high quality replacement and upgrade components. Hot molded Carbon element, gold-plated terminals, stainless steel shaft and housing. Mechanical rotation: 314° ¼" shaft diameter, 3/8" bushing diameter, 3/8" shaft length, ½" bushing length.


Please Log In to
view prices
Click to read more
R-VPEXASP-1Potentiometer - PEC Guitar, Audio, Split Shaft
Resistances Available:
Precision Electronic Components (PEC) Potentiometers are very high quality replacement and upgrade components. Hot molded Carbon element, gold-plated terminals, 24mm potentiometer with stainless steel split knurled shaft and one piece brass housing. Mechanical rotation: 300°, ¼" shaft diameter, 3/8" bushing diameter, 3/8" shaft length, ¼" bushing length. 1 watt.

Includes 1 nut and 1 lock washer.
Please Log In to
view prices
Click to read more
R-V38-KITPot Kit - Alpha, ⅜" Bushing, 25 pcs

Kit of Alpha potentiometers with 3/8" bushing. Contains the following quantities & values



  • 6 - 1MA (R-V38-1MA)
  • 3 - 250KA (R-V38-250KA)
  • 2 - 100KA (R-V38-100KA)
  • 2 - 100KL (R-V38-100KL)
  • 2 - 250KL (R-V38-250KL)
  • 2 - 25KA (R-V38-25KA)
  • 2 - 25KL (R-V38-25KL)
  • 2 - 500KA (R-V38-500KA)
  • 2 - 500KL (R-V38-500KL)
  • 2 - 5KL (R-V38-5KL)

Please Log In to
view prices
Click to read more
R-VPEXASS-1Potentiometer - PEC Guitar, Audio, Solid Shaft
Resistances Available:

Precision Electronic Components (PEC) Potentiometers are very high quality replacement and upgrade components. Hot molded Carbon element, gold-plated terminals, 24mm potentiometer with stainless steel slotted solid shaft and one piece brass housing. Mechanical rotation: 300°, ¼" shaft diameter, ⅜" bushing diameter, ⅜" shaft length, ¼" bushing length. 1 watt.


Please Log In to
view prices
Click to read more
P-ECB-24DPotentiometer - Dunlop, 250k Audio, for Dunlop GCB80

250K gear shaft pot with an audio taper. Original Dunlop replacement part. Used in the Dunlop GCB80 High Gain Volume Pedal.


Please Log In to
view prices
Click to read more
P-ECB-24APotentiometer - Dunlop Hot Potz, 470K

Used in Jimi Hendrix's WAH and Dunlop volume pedal. 470K ohm. Original Dunlop replacement part.


Please Log In to
view prices
Click to read more
R-VPMT-DMTLPotentiometer - PMT, Dual Mode Tone Control, ¾" Shaft/Bushing

Precision Music Technologies DMT Control – Dual Mode High Pass & Low Pass Tone Control. Made in USA. The DMT Tone Control is a passive dual mode tone filter than can operate in either high pass or low pass modes. This greatly expands the utility of the instruments controls vs. a traditional tone control. A frequency selector switch for each mode further adds to the DMT Controls versatility. Push-pull pot: 500KA, 16 mm body diameter, ¼” knurled split shaft. Bushing diameter = 3/8”, Bushing Length = 3/4”. PCB dimentions: 1.06” x 0.70” x 0.07”


Please Log In to
view prices
Click to read more
P-ECB-24BPotentiometer - Dunlop, Hot Potz II Crybaby, 100K

Hot Potz II Crybaby Pot. for newer Crybaby models. Made by Beckman. 100K ohm. Original Dunlop replacement part. The same tone and sweep characteristics as the original Cry Baby Hot Potz potentiometer with low wiper noise and extended life.


Please Log In to
view prices
Click to read more
P-ECB-24CPotentiometer - Dunlop, 20K, Custom Taper, Wah Pot, for Bass

Custom taper 20k Dunlop potentiometer used in 105Q Crybaby Bass Wah. 1 million cycles, maintenance free.


Please Log In to
view prices
Click to read more
R-VPMT-HCPPotentiometer - PMT, Humbucker Control, Coil Filters

Precision Music Technologies HCP Control – Humbucker Control Pot w/ Coil Filter Modes. Made in USA. The HCP Humbucker Control Pot is a passive dual mode coil selector that eliminates the additional switches associated with coil splitting a pair of humbuckers which greatly simplifies operation. Push-pull pot: 500KA, 16 mm body diameter, ¼” knurled split shaft. Bushing diameter = 3/8”, Bushing Length = 3/8”. PCB dimentions: 1.06” x 0.70” x 0.07”


Please Log In to
view prices
Click to read more

Pages

(16 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Potentiometers